Table of Contents
Advertisement
Activating the appliance
Standby
The appliance goes into standby mode if no function
has been set or the child lock is activated.
The brightness of the control panel is dimmed in
standby mode.
Notes
‒
Different displays are available for standby mode.
The default setting is the GAGGENAU logo and
the clock. To change the display, refer to the
settings
section.
‒
The brightness of the display depends on the
vertical viewing angle. You can adjust the display
using the "Brightness" setting in the basic
settings.
Activating the appliance
To exit standby mode, you can either
▯
Turn the function selector,
▯
Touch a control panel,
▯
Open or close the door.
You can now set the desired function. You can read
about how to set functions in the respective chapters.
Notes
‒
When "Standby screen = off" is selected in the
basic settings, you must turn the function selector
to exit standby mode.
‒
The appliance returns to the standby screen if you
have not made any settings for a long time after
activation.
‒
When the door is open, the interior lighting
switches off after a short time.
Operating the appliance
Filling the water tank
When you open the appliance door, you will see the
water tank on the side.
Caution! Use of unsuitable liquids may damage the
appliance
‒
Only use fresh tap water, softened water or
uncarbonated mineral water.
‒
If your tap water is very hard, we recommend that
you use softened water.
‒
Do not use distilled water, highly chlorinated tap
water (> 40 mg/l) or other liquids.
You can obtain information about your tap water from
your water supplier. The water hardness can be
checked with the test set enclosed.
Fill the water tank before every operation (except for
"Hot air + 30% humidity", "Hot air + 0% humidity" and
"Drying program"):
Basic
1
Open the appliance door and take out the water
tank (fig. A).
2
Fill the water tank with cold water up to the "max"
mark (fig. B).
3
Close the tank cover until you feel it engage.
4
Slide in the water tank all the way (fig. C).
The tank must be flush with the water tank recess
(fig. D).
13
Advertisement
Table of Contents
