Removing The Rails; C Atalytic Cleaning (Cleaning Aid); Preparing Catalytic Cleaning; Starting Catalytic Cleaning - Gaggenau BOP 210 1.2 Instruction Manual

Removing the rails

The rails can be removed for cleaning.
Detaching the rails
1
Lift up the front of the rail and unhook it (figure A).
2
Then pull the whole rail forward and remove it
(Fig. B).
Clean the rails with cleaning agent and a sponge. For
stubborn deposits of dirt, use a brush.
Refitting the rails
1
First insert the rail into the rear socket and press it
to the back slightly (figure A).
2
Then hook it into the front socket (figure B).
The rails fit both the left and right sides. Ensure that, as
shown in figure B, the recess is below.
Catalytic cleaning (cleaning aid)

C atalytic cleaning (cleaning aid)

.
Y ou can order an oven ceiling and an oven back wall,
C a t a l y t i c c l e a n i n g ( c l e a n i n g a i d )
which are coated with a special catalytic enamelling, for
the cooking compartment as a spare part. Dirt is
removed at high temperatures during the catalytic
cleaning.
This process does not clean the non-catalytic
components, such as the cooking compartment floor,
side walls, inside of the door and glass panel.
You can delay the catalytic cleaning switch-off time (for
example, if you want the catalytic cleaning to run during
the night).
m
Warning – Risk of burns!
The appliance will become very hot on the outside
during the cleaning function. Never touch the appliance
door. Allow the appliance to cool down. Keep children
at a safe distance.

Preparing catalytic cleaning

▯
Remove coarse soiling and food remainders from
the oven.
▯
Clean the oven interior base and side walls
manually, the door seals, the inside of the door and
the glass panel because the catalytic cleaning
process does not clean these parts.
▯
Remove all loose interior parts from the oven
interior. There must be no objects left in the
interior.
▯
Close the oven door.

Starting catalytic cleaning

1 Set the function selector to S.
2
œ symbol is displayed. Confirm with ™.
The
3
The switch-off time, when catalytic cleaning will be
finished, is displayed. If required, move the switch-
off time with the rotary selector. Confirm with ™.
4
Remove all accessories and coarse soiling from the
oven interior. Confirm with ™.
5
Press I to start. The cleaning time elapses on the
display. If the switch-off time has been shifted, the
time up to the start of catalytic cleaning elapses in
the display. The lamp in the oven interior stays off.
A signal sounds after the catalytic cleaning has expired.
A message appears in the display. Leave the appliance
to cool down.
en
27