Creating Marks; Creating A New Mark Using The Chart Page; Editing A Mark - Standard Horizon CP300i Owner's Manual

7.

CREATING MARKS

A User Point is an object that you can place on the charts to mark a specific point. The GPS
Chart Plotter features two types of User Points: Marks and Waypoints.
· Mark can be a stand alone position or be linked to a Route. A Mark is place on the Chart
page using the [MARK] key or by entering in information in the Marks/Waypoints List
page and selecting NEW MARK.
· Waypoints are always liked to a Route. They are placed on the Chart page using the
[ROUTE] key.
The difference betwen a Mark and a Waypoint is
a. when a Route is created using Waypoints and the Route is deleted the Waypoints are also
deleted.
b. if a Route is created using Marks and the Route is deleted the Marks remain.
7.0

CREATING A NEW MARK USING THE CHART PAGE

1. Move the ShuttlePoint knob to the desired or approx. Lat/Lon and press [MARK].
2. You will notice a Mark is placed under the location of the cursor and a popup window
is shown with the exact Lat/Lon of the Mark.
3. If the position is incorrect on the CP180/CP180i press [ENT], select EDIT using the
ShuttlePoint knob and press [ENT]. On the CP300/CP300i, press [E
you to change the position, Mark name and icon type. Refer to Par. 7.1 for details.
After entering in all the Marks it is a good practice to backup the points to an User C-CARD. Refer
to Section 11.
7.1

EDITING A MARK

If a Mark has previously been created and you wish to Edit it, move cursor over the top of
the Mark.
Page 60
NOTE
Figure 7.0 - Mark creation
NOTE
] that will allow
DIT
GPS Chart Plotters