Creating Marks; Creating A New Mark Using The Chart Page; Editing A Mark - Standard Horizon CP180 Owner's Manual

7.

CREATING MARKS

Definitions:
MARK Can be a stand alone position or be linked to a Route. A Mark is placed on
the Chart Page using the [MARK] key
or by entering in information in the MARK/WAYPOINTS menu and selecting
NEW MARK.
WAYPOINT is linked to a Route and placed on the Chart page using the [ROUTE] key.
The difference between a Mark and a Waypoint is
a. When a Route is created using WAYPOINTS and the ROUTE is deleted the WAYPOINTs are
also deleted.
b. If a Route is created using MARKS and the ROUTE is deleted the MARKs remain.
7.0

CREATING A NEW MARK USING THE CHART PAGE

1. Move the ShuttlePoint knob to the desired or approx. Lat/Lon and press [MARK].
2. You will notice a Mark is placed under the location of the cursor and a popup window is
shown with the exact Lat/Lon of the Mark.
3. If the position is incorrect on the CP180/CP180i press [ENT], select EDIT using the
ShuttlePoint knob and press [ENT]. On the CP300/CP300i, press [E
you to change the position, Mark name and icon type. Refer to Par. 7.1 for details.
After entering in all the Marks it is a good practice to back up the points to an User C-CARD. Refer
to Section 11.
7.1

EDITING A MARK

If a Mark has previously been created and you wish to Edit it, move cursor over the top of
the Mark.
GPS Chart Plotters
NOTE
Figure 7.0 - Mark creation
NOTE
] that will allow
DIT
Page 59