This Is How You Install The Mcp 310C Pn - Siemens SINUMERIK 828D Service Manual

Service cases - hardware
4.4 Machine control panels
Procedure:
1. Switch-off the control: Completely switch off the system. Check that the system is in a no-
2. Access the operator panel or control cabinet in which the machine control panel is
3. Using a multimeter, check the X10 power supply to ensure that the system really is in a
4. If it has not already been done, label all connectors that lead to the module now. Only
5. Withdraw the power supply X10 (
6. Release the strain relief of the Ethernet cable (
7. Remove the Ethernet cables from the X20/X21 interface (port 1/port 2) (
8. Release other cables (e.g. the Emergency Stop cable or the button from the mini
9. Remove the ground connection by releasing the grounding screw (
10. Release the machine control panel from the control panel by releasing the clips.
11. Note down the set address S2 (
4.4.3

This is how you install the MCP 310C PN

Installing
Procedure:
1. Set DIL switch S2 of the new module to what you previously noted down.
2. Install the new machine control panel.
3. Secure the clips to retain the machine control panel and tighten them.
4. Connect the ground connection (
5. Reconnect the other cables (e.g. the Emergency Stop cable or the button from the mini
6. Reinsert the Ethernet cables at the X20/X21 interface (port 1/port 2) (
7. Re-establish the strain relief for the Ethernet cables (
8. Reconnect the power supply X10 (
9. Close the cabinet and switch-on the system again.
92
voltage condition and is locked-out so that it cannot be switched on again without the
appropriate authorization.
located.
no-voltage condition.
then, can it be ensured that the cables are not interchanged.
handheld unit or from other command devices), if available.
handheld unit or from other command devices), if available.
②
).
⑧
)
⑥
) at the DIL switch of the defective module.
⑪
).
⑧
②
).
Service Manual, 03/2010, 6FC5397-5DP20-0BA0
⑨ ⑩
,
⑪
).
⑨ ⑩
, ).
).
Hardware and Software
).