Siemens SINUMERIK 828D Service Manual page 43

9. The software update is started: The following message appears while the update is
10. Wait until the following message is output:
11. Withdraw the storage medium from the slot.
12. Switch the control off.
13. Switch the control on.
14. The control boots normally.
Hardware and Software
Service Manual, 03/2010, 6FC5397-5DP20-0BA0
running:
NOTICE
If the update is interrupted, then it must be restarted.
If the system CompactFlash Card is no longer identified as bootable system, then a mini
boot system must be generated on this card (see also: This is how you generate a mini
boot system (Page 44)).
In this case, the license key of the system CompactFlash Card should be transferred to
the control.
Service cases - software
3.4 Software update
43