Siemens SINUMERIK 828D Service Manual page 143

3. Slide the components along the mounting rail to either the left or right up to their final
4. Screw on the protective conductor connection.
5. Screw on the encoder connecting cable to X520 or X521 / X531, if required, also the
6. Insert the DRIVE-CLiQ cable at X500.
7. Insert connector X524 for the electronics power supply.
Hardware and Software
Service Manual, 03/2010, 6FC5397-5DP20-0BA0
position.
shield connection.
CAUTION
The 50 mm clearances above and below the components must be observed.
Service cases - hardware
4.11 SMC20 / SMC30
143