Siemens SINUMERIK 828D Service Manual page 45

Precondition to write:
● RCS Commander has been installed.
● SW package: Configuration data from the Toolbox has been installed.
● CompactFlash card is a replacement card.
Installing the boot system on an empty card
Procedure:
1. Insert the CompactFlash Card into the card reader.
2. Start the RCS Commander via "Start" → "Programs" → "RCS Commander".
3. If you are prompted to establish the connection, press "Cancel".
4. In the "View" menu, select the menu item "Expert view".
5. Select menu item "Generate 828D boot system".
Hardware and Software
Service Manual, 03/2010, 6FC5397-5DP20-0BA0
Note
An online connection to the control is not required to generate the boot system.
The following, additional "NC commissioning" menu is displayed:
3.5 Mini boot system on the CompactFlash Card
Service cases - software
45