Siemens SINUMERIK 828D Service Manual page 87

8. Then assemble the two housing sections again. To do this, locate the printed circuit
9. Press the two housing sections together so that the lugs of the fasteners click into place
Result
SIM card is ready; screw the SINAUT modem together again.
Hardware and Software
Service Manual, 03/2010, 6FC5397-5DP20-0BA0
board in the upper and lower rails inside the rear section of the housing.
①
Rail for the printed circuit board
at the top and bottom.
Service cases - hardware
4.3 SINAUT modem
87