Configuration > 802.3Ah Ethernetlink Oam > Ethernet Oam Port Settings; Configuration > 802.3Ah Ethernetlink Oam > Ethernet Oam Event Configuration - D-Link DSG-1100-10/ME Manual

D-Link DGS-1100-10/ME User Manual
DHCPv6 Relay Hops Count Limit (1-32): The field allows and entry between 1 and 32 to define the
maximum number of router hops DHCPv6 messages can be forwarded. The default hop count is 4.
DHCPv6 Relay Option37 State: Specifies the DHCPv6 Relay Option37 State to be enabled or disabled.
DHCPv6 Relay Option37 Check: Specifies the DHCPv6 Relay Option37 Check to be enabled or disabled.
DHCPv6 Relay Option37 Remote ID Type: Specifies the DHCPv6 Relay Option37 Remote ID type is CID
with User Defined, User Defined or Default.
Interface: Enter a name of the interface.
Server IP: Enter the server IP address.
Click Apply to implement changes made.
Configuration > 802.3ah EthernetLink OAM > Ethernet OAM Port Settings
Ethernet OAM (Operations, Administration, and Maintenance) is a data link layer protocol which provides
network administrators the ability to monitor the health of the network and quickly determine the location of
failing links or fault conditions on point-to-point and emulated point-to-point Ethernet link.
The Ethernet OAM Port Settings page allows you to configure the Ethernet OAM settings.
Figure 4.74 - Configuration > 802.3ah EthernetLink OAM > Ethernet OAM Port Settings
From Port / To Port: Select a range of ports to be configured.
Mode: Select either active mode or passive mode. The default mode is active.
State: Select to enable or disable the OAM function. The default state is disabled.
Remote Loopback: If start is specified, it will request the peer to change to the remote loopback mode. If
stop is specified, it will request the peer to change to the normal operation mode.
Received Remote Loopback: Select whether to process or to ignore the received Ethernet OAM remote
loopback command. The default method is Ignore.
Click Apply to implement changes made.
Configuration > 802.3ah EthernetLink OAM > Ethernet OAM Event Configuration
The Ethernet OAM Event Configuration page allows user to configure the Ethernet OAM Event settings.
4 4 7 7