System > Ieee802.3Az Eee Settings - D-Link DSG-1100-10/ME Manual

D-Link DGS-1100-10/ME User Manual
By reducing power consumption less heat is produced resulting in extended product life and lower operating
costs. By default, Cable Length Detection and Link Status Detection are enabled. Select either Enabled or
Disabled. If you select Enabled, make any changes to the settings below and click Apply.
Advanced Power Saving Settings:
Type: Select the Power Saving type. Select either LED Shut-off, Port Shut-off, Port Standby or System
Hibernation.
LED Shut-off - Select LED Shut-off to turn off the LEDs on the selected port(s). Select the time
profile that you want the LEDs to turn off.
Port Shut-off - Select to turn off the selected port(s) on the Switch. Select the time profile that you
want the port(s) to turn off.
Port Standby - The system changes to standby state and wait for a wake up event. Select the time
profile(s) to place the Switch in port standby mode.
System Hibernation - In this mode, switches get most power-saving figures since main chipsets
(both MAC and PHY) are disabled for all ports, and energy required to power the CPU is minimal.
State: Select Enable or Disable.
Time Profile 1: Select the time profile or None.
Time Profile 2: Select the time profile or None.
Port: Select the port or ports to apply to the power saving type selected.
Click Select All configure all ports, or click Clear to uncheck all ports. Then click Apply to implement
changes made.
System > IEEE802.3az EEE Settings
The IEEE 802.3 EEE standard defines mechanisms and protocols intended to reduce the energy
consumption of network links during periods of low utilization, by transitioning interfaces into a low-power
state without interrupting the network connection. The transmitted and received sides should be
IEEE802.3az EEE compliance. By default, the switch enabled the 802.3az EEE function. You can disable
this feature by individual port via the IEEE802.3az EEE setting page.
Figure 4.42 – System > Power Saving
3 3 3 3