Configuration > Multicast Forwarding & Filter > Multicast Forwarding; Configuration > Multicast Forwarding & Filter > Multicast Filter Mode - D-Link DSG-1100-10/ME Manual

D-Link DGS-1100-10/ME User Manual
Admin State: Enable or disable the administration state. This indicates these ports unidirectional link
detection status. The default state is Disabled.
Mode: Toggle between Shutdown and Normal. When Shutdown is selected if any unidirectional link is
detected, this feature will disable the port and log an event. When Normal is selected, this feature will only
log an event when a unidirectional link is detected.
Discovery Time (sec): Enter the port neighbor discovery time between 5 and 65535 seconds. If the
discovery is timed out, the unidirectional link detection will start. The default discovery time is 5 seconds.
Click Apply to create a new entry.
Configuration > Multicast Forwarding & Filter > Multicast Forwarding
The Multicast Forwarding page displays all of the entries made into the Switch's static multicast forwarding
table.
Figure 4.77 - Configuration > Multicast Forwarding & Filter > Multicast Forwarding
VID: The VLAN ID of the VLAN to which the corresponding MAC address belongs.
Multicast MAC Address: The MAC address of the static source of multicast packets. This must be a
multicast MAC address.
Port Settings: Allows the selection of ports that will be members of the static multicast group and ports
either that are forbidden from joining dynamically, or that can join the multicast group dynamically, using
GMRP.
Egress - The port is a static member of the multicast group.
None - No restrictions on the port dynamically joining the multicast group. When None is chosen,
the port will not be a member of the Static Multicast Group.
Click Apply to implement changes made.
Configuration > Multicast Forwarding & Filter > Multicast Filter Mode
The Multicast Filtering Mode page allows you to set up the filtering mode.
4 4 9 9