System > Time Profile; System > Power Saving - D-Link DSG-1100-10/ME Manual

D-Link DGS-1100-10/ME User Manual
Server ID: Select the Server ID. The field range is 1-4.
Severity: Select the minimum severity from which warning messages are sent to the server. There are three
levels. When a severity level is selected, all severity level choices above the selection are selected
automatically. The possible levels are:
Warning - The lowest level of a device warning. The device is functioning, but an operational
problem has occurred.
Informational - Provides device information.
All - Displays all levels of system logs.
Facility: Select an application from which system logs are sent to the remote server. Only one facility can be
assigned to a single server. If a second facility level is assigned, the first facility is overwritten. There are up
to eight facilities can be assigned (Local 0 ~ Local 7).
UDP Port: Enter the UDP port to which the server logs are sent. The possible range is 6000 – 65535, and
the default value is 514.
Status: Select the status to enable or disable.
Server IP Address: Select either IPv4 or IPv6 and enter the syslog server IP address.
System > Time Profile
From this page you can configure the time profile settings of the device.
Profile Name: Enter a profile name.
Time(HH MM): Select a Start Time and End Time.
Weekdays: Select which days you want to use.
Date: Tick the Date box and select a range from the "From Day" and "To Day" fields.
Click Add to create a new time profile or click Delete to delete a time profile from the table.
System > Power Saving
The Power Saving mode feature reduces power consumption automatically when the RJ-45 port link is down
or the connected devices are turned off. Less power will be consumed also when a short cable is used (less
than 20 meters).
Figure 4.40 - System > System Log Configuration > System Log Server
Figure 4.41 – System > Time Profile Settings
NOTE: The time must be set after current time,
otherwise it will take effect on the next cycle time.
3 3 2 2