Turning The Projector On - Christie D13HD-HS User Manual

Turning the projector on

The projector cables must be securely connected before turning the power on.
Warning! PERMANENT/TEMPORARY BLINDNESS HAZARD! No direct exposure to the beam must be
permitted. RG3 IEC 62471:2006.
1. Ensure the correct power input has been selected.
Condition Power
Input
1 100-120V
2 100-120V
3 200-240V
4 200-240V
The Power button on the built in keypad is illuminated when the power cables are connected.
2. Ensure the lens has been installed in the projector by a Christie qualified service technician.
Warning! Failure to comply with the following could result in death or serious injury.
• Installing or replacing a lens must be done by a Christie qualified service technician to avoid
exposure to dangerous emission levels.
3. Ensure that no one or no objects are in the beam path before turning on the projector.
4. To turn on the projector, on the IR remote keypad press
HS Series User Manual
020-000883-03 Rev. 1 (07-2016)
AC Inlet Projector Behavior
selected
100-120V Full power (100%)
200-240V • Warning message appears on screen
• ECO 2 mode (50% power)
100-120V • Warning message appears on screen
• ECO 2 mode (50% power)
200-240V Full power (100%)
Applicable Regions
• North America
• Japan
• North America
• UK
• EU
• Russia
• Korea
• India
• Australia/Nz
• South Africa
• Argentina
or on the built-in keypad press
Installation
.
23