Table of Contents
Advertisement
3
SET MODE
Set mode items
D Set mode sequence
The table below describes the sequence of the items in the Set mode.
• The sequence is as shown below when you push [FUNC] in the Set mode.
• Squelch level
Starting item
• Scan mode
• CTCSS/DTCS*
1
• Backlight
• Beep
• Beep Level
• RF Power
*
1
Selected CTCSS or DTCS code is displayed.
*
2
May not be displayed, depending on the transceiver's setting.
*
3
5 digit Own ID is displayed.
• Horn
• Signal Monitor
• Auto Power Off
• Battery Voltage
• Roger Beep
• Lockout
• Quiet mode
3-2
• RX VFO
• Scan Stop Timer
• Scan Restart
• Mic Gain
• Lone Worker
*
2
• AF Minimum Level
*
2
• Own ID*
2
*
3
- Quick Links:
- Basic Operation
Hide quick links:
Advertisement
Chapters
Table of Contents
Need help?
Do you have a question about the IC-410PRO and is the answer not in the manual?
Questions and answers
I have the ic-41 pro. I can transmit but no longer receive. I’m not aware of any settings changing. I’m using ch15. The screen shows sql , q and below that. OS S in black squares
Your Icom IC-410PRO may be able to transmit but not receive on channel 15 due to one or more of the following reasons:
1. Quiet Mode (Selcall or Tone Squelch) is ON – If Quiet Mode is enabled, the radio will not unmute unless it receives the correct Selcall or tone. Turn OFF Quiet Mode in the Set mode.
2. Tone Squelch setting mismatch – If the tone squelch is set incorrectly or does not match the other radios, you will not hear incoming transmissions. Set the correct tone squelch setting for the user group.
3. Squelch level is set too high – If the squelch level is too high, weak signals may be blocked. Decrease the squelch level in the Set mode.
4. Monitor function is OFF – If the Monitor function is OFF, you might not hear transmissions that don’t match the squelch settings. Press [MONI] to temporarily open the squelch and check for incoming signals.
Check and adjust these settings to restore receiving capability on channel 15.
This answer is automatically generated