D Editing The Tx Code; D Transmitting An Individual Selcall - Icom IC-410PRO Advanced Manual

7
SELCALL (Selective Calling)
Calling (Continued)

D Editing the TX code

You can edit the TX code within the allowed digits.
The Group call function enables you to edit a special
"Group code" of the Selcall ID code.
1) Select the desired CB channel or Repeater
channel, except for CB channel 5, 35, and
Repeater channel 5.
➥ Push [UP]/[DOWN].
2) Turn ON the Function mode.
➥ Push [FUNC].
• " " is displayed.
3) Enter the TX Code Selection mode.
➥ Push [SCAN].
4) Enter the TX Code Editing mode.
➥ Hold down [SCAN] for 2 seconds.
• The editing digit blinks.
5) Edit the TX code.
➥ Push [UP]/[DOWN].
6) Go to next digit.
➥ Push [SCAN].
7) Repeat step 5) and 6) to enter all digits.
8) Exit the TX Code Editing mode.
➥ Push [SCAN].
• The editing digit stops blinking.
9) Push [PTT] to transmit the selected TX code, or
push [SCAN] to set the selected TX code and exit
the TX Code Selection mode.
• When you transmit, a short beep sounds.
NOTE: The TX code digits that can be edited by
the user are set using the CS-410PRO
.
software

D Transmitting an individual Selcall

1) Turn ON the Function mode.
➥ Push [FUNC].
2) Enter the TX Code Selection mode.
➥ Push [SCAN].
3) Select the desired TX code.
➥ Push [UP]/[DOWN].
4) Transmit an individual call.
➥ Push [PTT].
TIP: If you have already selected the TX code, you
can transmit an individual Selcall as shown below.
1) Turn ON the Function mode.
➥ Push [FUNC].
2) Transmit an individual call.
➥ Hold down [SCAN] for 2 seconds.
cloning
7-3
• " " is displayed.
• A short beep sounds.
• " " is displayed.
• A short beep sounds.