H3C S5500-SI Series Operation Manual page 682

Use the following command to view 802.1X authentication information:
<Switch> display dot1x interface gigabitethernet 1/0/1
Equipment 802.1X protocol is enabled
CHAP authentication is enabled
EAD quick deploy is disabled
Configuration: Transmit Period
Quiet Period
Supp Timeout
The maximal retransmitting times
EAD quick deploy configuration:
EAD timeout:
Total maximum 802.1X user resource number is 1024 per slot
Total current used 802.1X resource number is 1
GigabitEthernet1/0/1
802.1X protocol is enabled
Handshake is enabled
The port is an authenticator
Authentication Mode is Auto
Port Control Type is Mac-based
802.1X Multicast-trigger is enabled
Mandatory authentication domain: NOT configured
Guest VLAN: NOT configured
Max number of on-line users is 256
EAPOL Packet: Tx 16331, Rx 102
Sent EAP Request/Identity Packets : 16316
EAP Request/Challenge Packets: 6
EAP Success Packets: 4, Fail Packets: 5
Received EAPOL Start Packets : 6
EAPOL LogOff Packets: 2
EAP Response/Identity Packets : 80
EAP Response/Challenge Packets: 6
Error Packets: 0
1. Authenticated user : MAC address: 0002-0000-0011
Controlled User(s) amount to 1
In addition, as NTK is enabled, frames with unknown destination MAC addresses, multicast addresses,
and broadcast addresses should be discarded.
30 s, Handshake Period
60 s, Quiet Period Timer is disabled
30 s, Server Timeout
30m
is link-up
1-19
15 s
100 s
2