H3C S5500-SI Series Operation Manual page 358

Configuration procedure
1) Configure the IPv6 addresses of all VLAN interfaces (Omitted)
2) Configure IPv6 static routes.
# Configure the default IPv6 static route on SwitchA.
<SwitchA> system-view
[SwitchA] ipv6 route-static :: 0 4::2
# Configure two IPv6 static routes on SwitchB.
<SwitchB> system-view
[SwitchB] ipv6 route-static 1:: 64 4::1
[SwitchB] ipv6 route-static 3:: 64 5::1
# Configure the default IPv6 static route on SwitchC.
<SwitchC> system-view
[SwitchC] ipv6 route-static :: 0 5::2
3) Configure the IPv6 addresses of hosts and gateways.
Configure the IPv6 addresses of all the hosts based upon the network diagram, configure the default
gateway of Host A as 1::1, that of Host B as 2::1, and that of Host C as 3::1.
4) Display configuration information
# Display the IPv6 routing table of SwitchA.
[SwitchA] display ipv6 routing-table
Routing Table :
Destinations : 5
Destination : :: /128
NextHop : FE80::510A:0:8D7:1
Interface : Vlan-interface200
Destination : ::1/128
NextHop : ::1
Interface : InLoop0
Destination : 1:: /64
NextHop : 1::1
Interface : Vlan-interface100
Destination : 1::1/128
NextHop : ::1
Interface : InLoop0
Destination : FE80::/10
NextHop : ::
Interface : NULL0
# Verify the connectivity with the ping command.
[SwitchA] ping ipv6 3::1
PING 3::1 : 56 data bytes, press CTRL_C to break
Routes : 5
Protocol
Preference
Cost
Protocol
Preference
Cost
Protocol
Preference
Cost
Protocol
Preference
Cost
Protocol
Preference
Cost
1-3
: Static
: 60
: 0
: Direct
: 0
: 0
: Direct
: 0
: 0
: Direct
: 0
: 0
: Direct
: 0
: 0