H3C S5500-SI Series Operation Manual page 678

[Switch] dot1x authentication-method chap
3) Configure port security
# Enable port security.
[Switch] port-security enable
# Add five OUI values.
[Switch] port-security oui 1234-0100-1111 index 1
[Switch] port-security oui 1234-0200-1111 index 2
[Switch] port-security oui 1234-0300-1111 index 3
[Switch] port-security oui 1234-0400-1111 index 4
[Switch] port-security oui 1234-0500-1111 index 5
[Switch] interface gigabitethernet 1/0/1
# Set the port security mode to userLoginWithOUI.
[Switch-GigabitEthernet1/0/1] port-security port-mode userlogin-withoui
4) Verify the configuration
After completing the above configurations, you can use the following command to view the
configuration information of the RADIUS scheme named radsun:
<Switch> display radius scheme radsun
SchemeName : radsun
Index : 1
Primary Auth IP : 192.168.1.2
Primary Acct IP : 192.168.1.3
Second Auth IP : 192.168.1.3
Second Acct IP : 192.168.1.2
Auth Server Encryption Key : name
Acct Server Encryption Key : money
Interval for timeout(second)
Retransmission times for timeout
Interval for realtime accounting(minute)
Retransmission times of realtime-accounting packet
Retransmission times of stop-accounting packet
Quiet-interval(min)
Username format
Data flow unit
Packet unit
Use the following command to view the configuration information of the ISP domain named sun:
<Switch> display domain sun
Domain = sun
State = Active
Access-limit = 30
Accounting method = Required
Default authentication scheme
Default authorization scheme
Default accounting scheme
Domain User Template:
Idle-cut = Disabled
Type : standard
Port : 1812 State : active
Port : 1813 State : active
Port : 1812 State : active
Port :1813 State : active
: 5
: 5
: 15
: 5
: 500
: 5
: without-domain
: Byte
: one
: radius=radsun
: radius=radsun
: radius=radsun
1-15