Rip Configuration Examples; Configuring Rip Version - H3C S5500-SI Series Operation Manual

To do...
Display RIP interface
information
Display routing information
about a specified RIP process
Clear the statistics of a RIP
process

RIP Configuration Examples

Configuring RIP Version

Network requirements
As shown in Figure
Figure 1-4 Network diagram for RIP version configuration
Configuration procedure
1) Configure an IP address for each interface (only the IP address configuration for the VLAN
interfaces is given in the following examples)
# Configure Switch A.
<SwitchA> system-view
[SwitchA] interface vlan-interface 100
[SwitchA-Vlan-interface100] ip address 192.168.1.3 24
[SwitchA-Vlan-interface100] quit
[SwitchA] interface vlan-interface 101
[SwitchA-Vlan-interface101] ip address 172.17.1.1 24
[SwitchA-Vlan-interface101] quit
[SwitchA] interface vlan-interface 102
[SwitchA-Vlan-interface102] ip address 172.16.1.1 24
# Configure Switch B.
<SwitchB> system-view
[SwitchB] interface vlan-interface 100
[SwitchB-Vlan-interface100] ip address 192.168.1.2 24
[SwitchB-Vlan-interface100] quit
[SwitchB] interface vlan-interface 101
[SwitchB-Vlan-interface101] ip address 10.2.1.1 24
[SwitchB-Vlan-interface101] quit
2) Configure basic RIP functions
Use the command...
display rip process-id interface
[ interface-type interface-number ]
display rip process-id route
[ ip-address { mask | mask-length } |
peer ip-address | statistics ]
reset rip process-id statistics
1-4, enable RIPv2 on all interfaces on Switch A and Switch B.
1-16
Remarks
Available in user view