Common Configuration; Console Port Login Configuration - H3C S5500-SI Series Operation Manual

Figure 2-4 Set port parameters terminal window
Turn on the switch. The user will be prompted to press the Enter key if the switch successfully
completes POST (power-on self test). The prompt (such as <H3C>) appears after the user presses
the Enter key.
You can then configure the switch or check the information about the switch by executing
commands. You can also acquire help by type the ? character. Refer to the following chapters for
information about the commands.

Console Port Login Configuration

Common Configuration

Table 2-2 lists the common configuration of Console port login.
Table 2-2 Common configuration of Console port login
Configuration
Enter system view
Enter AUX user interface view
Console (AUX
user
interface)port
configuration
system-view
user-interface aux 0
Baud rate speed speed-value
parity { even | mark |
Check mode
none | odd | space }
Stop bits stopbits { 1 | 1.5 | 2 }
—
—
Optional
The default baud rate is 9,600
bps.
Optional
By default, the check mode of
the Console port is set to
"none", which means no check
bit.
Optional
The default stop bits of a
Console port is 1.
2-3
Description