External Connections
CS-series I/O Connecting Cables
CS-series → C200H I/O Connecting Cables
2-5-3 Connecting DeviceNet Communications Cables
Preparing Cables
1, 2, 3...
44
5. Do not bend or pull on the Cables forcefully.
6. The cable's pull strength is 49 N.
7. The following diagrams show how sharply the Cables can be bent.
R ≥ 69 mm is required.
(The cable's outer
diameter is 8.6 mm.)
R ≥ 41 mm is required.
(The cable's outer
diameter is 5.1 mm.)
The DeviceNet communications cables can be installed as soon as the SYS-
MAC CS1 Board is installed in the computer. This manual provides information
only on wiring the communications cables to the SYSMAC CS1 Board. Refer to
the CS/CJ Series DeviceNet Unit Operation Manual (W380) for details on wiring
communications cables and Slaves.
This section explains how to prepare and connect the communications cables to
connectors for the DeviceNet Network. Use the following procedure to prepare
and connect the communications cables to the connectors.
1. Remove about 30 mm of the cable covering being careful not to damage the
shield weaving underneath. Do not remove more than about 30 mm; remov-
ing too much of the covering can result in short-circuits.
C200H I/O Connecting Cables
R ≥ 41 mm is required.
(The cable's outer
diameter is 5.1 mm.)
About 30 mm
Section
2-5