Error Processing - Omron SYSMAC CS1 Operation Manual

Error Processing

Recommended Cable Components
Connector Pin Allocation
2-6

Error Processing

48
power supply, the Board's ladder program will continue to be executed even if
the computer is turned OFF.
External power supply
input terminals
Note 1. Use the following recommended cable components or equivalents to make
the power supply connecting cable.
2. Design the power supply side of the connecting cable to meet the require-
ments of your system.
3. A C200PC-PD024 Power Supply Board cannot be used.
Component
Socket housing
Socket contact
Cable
Pin Signal
1 5 V
2 5 V
3 Reserved
4 0 V
5 0 V
Note 1. Do not connect anything to pin number 3.
2. Refer to 1-11 Specifications for details on the Board's current consumption
and use a power supply with some extra output capacity.
Refer to the appropriate manual below for information on identifying and correct-
ing PLC errors and DeviceNet errors.
• PLC errors: CS-series Programmable Controllers Operation Manual (W339)
• DeviceNet errors: CS/CJ Series DeviceNet Unit Operation Manual (W380)
Refer to the User's Manual included with the ITBC-SC1W-CD SYSMAC CS1
Board Driver for details on troubleshooting errors related to the SYSMAC CS1
Board Driver.
Note Before troubleshooting errors, check that the Board is installed correctly. If the
Board is not screwed tightly into the slot, the card edge connector may not be
contacting the computer's PCI slot completely. The Board will not operate prop-
erly if there isn't proper contact between the Board and slot.
To power supply
Model number
IL-S-5S-S2C2-S
IL-S-C2-S-10000
10007#26
Section 2-6
Manufacturer
JAE
JAE
Sumitomo