Dunkirk XEB-2 Installation Instructions Manual
Dunkirk XEB-2 Installation Instructions Manual

Dunkirk XEB-2 Installation Instructions Manual

Gas-fired hot water induced craft boilers

Advertisement

Gas-Fired
Hot Water
Induced
Draft
BOILERS
INSTALLATION INSTRUCTIONS
These instructions
must affixed on or adjacent to the boiler.
MODELS
XEB-2
XEB-3
XEB-4
XEB-5
XEB-6
XEB-7
This boiler cannot be used with all types of
chimneys.
Read these instructions
carefully
before installing.
These Gas-Fired
Hot Water Boilers are low pressure,
sectional
cast
iron
boilers
Design
Certified
by C.S.A.
(Canadian
Standards
Association)
for use with Natural
and Propane
Gases.
They
are
constructed
and hydrostatically
tested for a maximum
working pressure
of 50 psi in accordance
with A.S.M.E.
Boiler and Pressure
Vessel
Code Section
IV Standards
for cast iron heating
boilers.
WARNING:
Improper
installation, adjustment,
alteration,
service or maintenance
can cause injury
or property damage.
Refer to this manual. For assistance
or information
consult a qualified
installer,
service agency or the gas supplier.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Xeb-3Xeb-6Xeb-7Xeb-4Xeb-5

Table of Contents