Response After Changing An Individual Component - Siemens SITOP PSU8600 Manual

Installation and maintenance
4.6 System response for a modified hardware configuration
overload" (LED is lit red) or "Ready for reset" (LED flashes red), then these operating states
are again assumed when the system starts.
4.6.1

Response after changing an individual component

A change involves replacing an individual component by an individual component with a
different order number (not the identical type).
NOTICE
Incorrect response and damage after switching on again
Different settings and an incorrectly wired new component can result in an incorrect
response and subsequent damage.
When replacing an individual component, it must be ensured that the new component has
the same settings as the component that has been replaced in order to avoid an incorrect
response and damage after you switch-on again.
After replacing the component, ensure that the wiring via the plug-in terminals is correct.
Note
For replacing components by an identical component type, proceed as described under
Replacing individual components (Page 87).
Response after making a change and powering up in the MANUAL mode
● Buffer modules are automatically commissioned.
● For expansion modules, after switching on again, the outputs are in the operating state
"manually shutdown" (the LEDs of the outputs are lit yellow).
The outputs are switched-on by pressing their associated buttons.
Response after making a change and powering up in the REMOTE mode
In this case, the system response depends on the specific case.
92
PSU8600power supply systems
Manual, 04.2016, A5E35883207-7-76