Siemens SITOP PSU8600 Manual page 129

Parameters of the expansion modules
For the parameterization of the expansion modules, in the navigation area, the settings
under "Module configuration > Outputs 1...4" are relevant.
Navigation area
Module con-
figuration
A detailed description of the individual parameters of the subgroup is provided in Section
Parameterizing outputs (Page 136).
Note
In addition, under "Module configuration > Output 1...4", by activating the point "The
configuration of the output can differ during runtime because it is controlled remotely" a note
can be saved as to whether the parameters for the output are controlled from a PLC program
during the runtime. For a download, this information is not written to the device, it is only
saved in the STEP 7 project file.
Parameters of buffer modules with electrolytic capacitors
With the exception of the standard settings for IO devices, the buffer modules with
electrolytic capacitors have no configurable parameters.
Parameters of buffer modules with double-layer capacitors
● BUF8600 4s/40A (6EP4293-8HB00-0XY0)
● BUF8600 10s/40A (6EP4295-8HB00-0XY0)
For the parameterization of the buffer modules with double-layer capacitors, in the navigation
area, select "General > Device configuration > Buffering".
PSU8600power supply systems
Manual, 04.2016, A5E35883207-7-76
Description
Outputs 1 ... 4 Here, make the following settings for the individual outputs:
Switch-on and switch-off output.
•
Setpoint output voltage.
•
Response threshold value of the output current
•
Define a threshold to issue an alarm.
•
An alarm is output if this threshold is continually exceeded for
5 ms.
Define the on delay.
•
Define the ELECTRONIC SHUTDOWN or CONSTANT
•
CURRENT operating modes
Engineering and remote access
7.3 SIMATIC STEP 7 in the TIA Portal
129