Lexmark MX71 Series Repair Manual page 418

8
Remove the two screws (D) securing the limit switch.
9
Disconnect the cable J7 from the controller board.
10
Route the cable off the stapler, and remove the stapler door close limit switch.
Note: Pay attention to the original routing of the cables.
Sensor (throat media present) removal
1
Remove the stapler right cover. See
2
Remove the stapler top cover. See
"Stapler right cover removal" on page
"Stapler/offset stacker top cover removal" on page
Repair information
788
782.
728.
7463