6
Remove the output bin sensor cover. See
7
Remove the sensor (standard bin full) with actuator. See
8
Remove the standard bin cover. See
9
Remove the control panel. See
10
Disconnect the left recoil spring.
11
Remove the e-clip (A) securing the pin to the left control panel hinge.
12
Remove the pin (B).
13
Remove the controller board access shield. See
"Output bin sensor cover removal" on page
"Standard bin cover removal (MX71x)" on page
"Control panel removal (MX71x)" on page
"Controller board access shield removal" on page
Repair information
517
"Sensor (standard bin full) removal" on page
488.
7463
564.
564.
565.
424.