6
Remove the copy of the target page from the printer. If the copy is spaced evenly on the top and both sides, then
the flatbed registration is complete.
If the copy is not centered, then you will need to make an adjustment.
7
Select Flatbed to make the flatbed adjustments.
8
Make adjustments as needed, and then select Submit.
9
Select Copy Quick Test and check the results.
10
Repeat steps 5 through 9 until the copy is evenly spaced on the top and both sides.
Note: Once a test page with evenly spaced margins is generated, keep the copy as an aid in setting the flatbed
magnification.
11
Register the front ADF:
a
Set the printed target page into the paper tray facing up, and then navigate to Configuration mode > Scanner
Manual Registration > Print Quick Test.
b
Remove the copy of the target page from the printer. If the copy is spaced evenly on the top margin and both
sides of the page, then the front side registration is complete.
If the copy is not spaced properly on the top and both sides, you will need to make an adjustment.
c
Select ADF Front to make the front adjustments.
Repair information
410
7463