7
Slightly move the shaft horizontally to release, and then remove it.
Warning—Potential Damage: Be careful not to lose the bushing and spacers that hold the shaft.
Installation note: To make it less difficult to reinstall the E-clip, use a pair of long-nose pliers to position it onto
the shaft, and then lock it in place.
Stapler/offset stacker chute assembly removal
Note: This is not a FRU.
1
Remove the stapler left cover. See
2
Remove the stapler right cover. See
3
Remove the stapler diverter plunger assembly. See
on page
760.
4
Remove the stapler drive gear assembly. See
5
Remove the stapler feed roll. See
"Stapler/offset stacker left cover removal" on page
"Stapler right cover removal" on page
"Stapler/offset stacker diverter plunger assembly removal"
"Stapler/offset stacker drive gear assembly removal" on page
"Stapler/offset stacker feed roll removal" on page
Repair information
767
726.
782.
765.
7463
761.