7
Disconnect the speaker cable (C) and bin LED cable (D), and then remove the four screws (E) securing the flatbed
scanner assembly on the right side of the printer.
8
Remove the four screws (E) securing the flatbed assembly on the right side of the printer.
9
Open the printer rear door.
10
Lift the flatbed scanner assembly to remove.
Installation note: Make sure to perform the following scanner calibration procedure after replacing the flatbed
scanner assembly:
1
Register the flatbed and front ADF. See
2
Retune the flatbed magnification. See
"Registering the flatbed and front ADF" on page
"Retuning the flatbed magnification (code P132 or greater)" on page
Repair information
629
7463
408.
413.