12
Remove the mylar plate (D) covering the sensor latches. Release the sensor latches.
13
From the other side of the frame, disconnect the sensor cable, and then remove the sensor from the frame.
Sensor (stapler/stacker diverter plunger HP) removal
1
Remove the stapler left cover. See
2
Remove the stapler right cover. See
3
Remove the stapler diverter plunger assembly. See
on page
760.
4
Remove the stapler drive gear assembly. See
5
Remove the stapler feed roll. See
6
Remove the stapler chute assembly. See
"Stapler/offset stacker left cover removal" on page
"Stapler right cover removal" on page
"Stapler/offset stacker diverter plunger assembly removal"
"Stapler/offset stacker drive gear assembly removal" on page
"Stapler/offset stacker feed roll removal" on page
"Stapler/offset stacker chute assembly removal" on page
Repair information
779
726.
782.
765.
767.
7463
761.