4
Remove the two screws (A) using a #1 Phillips screwdriver.
5
Route the cable off the drawer, then remove the lift plate drive motor.
Sensor (drawer pass through) removal
1
Remove the media tray. See
2
Remove the rear cover. See
3
Remove the left cover. See
4
Disconnect and release the cables (J4, J8 and J7) from the controller board.
Note: Pay attention to the original position of the cables.
"550-sheet media tray option removal" on page
"Drawer assembly rear cover removal" on page
"Drawer assembly left cover removal" on page
Repair information
699
688.
691.
692.
7463