2N Helios IP Configuration Manual page 41

device (WEB relay, e.g.) upon switch activation. The command is sent via the
HTTP (GET request) and must be as follows: http://ip_address/path. E.g.:
http://192.168.1.50/relay1=on
Command sent upon deactivation – set the command to be sent to the
external device (WEB relay, e.g.) upon switch deactivation. The command is sent
via the HTTP (GET request) and must be as follows: http://ip_address/path.
E.g.: http://192.168.1.50/relay1=off
Tip
In case of use external relay
commands:
In case of use external relay part no.: 9137411E are used next HTTP
commands (Symbol
Legacy switch code – enable the option to activate the first-listed switch
code from the phone without being confirmed with *.
first code does not require confirmation by *. This setting does not apply to other
switch codes listed and to numeric keypad code activation, those must be always
confirmed by *. The Legacy switch code helps you keep back compatibility with
earlier 2N intercom models.
Note
®
2N TELEKOMUNIKACE a.s., www.2n.cz
To turn on the switch - http://ip_address/state.xml?relayState=1 (e.g.:
http://192.168.1.10/state.xml?relayState=1)
To turn on for pre-defined time (default value is 1.5 s) -
http://ip_address/state.xml?relayState=2
http://192.168.1.10/state.xml?relayState=2)
To turn off - http://ip_address/state.xml?relayState=0
http://192.168.1.10/state.xml?relayState=0
X should be replaced with a number of the desired switch):
To turn on the switch - http://ip_address/state.xml?relayXState=1
(e.g.: http://192.168.1.10/state.xml?relay1State=1
To turn on for pre-defined time (default value is 1.5 s) -
http://ip_address/state.xml?relayXState=2
http://192.168.1.10/state.xml?relay1State=2
To turn off - http://ip_address/state.xml?relayXState=0
http://192.168.1.10/state.xml?relay1State=0
The switch time profiles are available with the Gold or Enhanced
Integration licence only.
.
part no.: 9137410E
)
)
)
are used next HTTP
(e.g.:
(e.g.:
)
(e.g.:
(e.g.:
When this box is checked,
41