Installation - GE D60 Instruction Manual
Line distance relay
Hide thumbs
Also See for D60:
- Instruction manual (826 pages) ,
- Communications manual (532 pages) ,
- Instruction manual (822 pages)
Table of Contents
Advertisement
5.2 PRODUCT SETUP
On two- terminals two-channel systems, the same
only the
TERMINAL 1 ID NUMBER
PATH: SETTINGS
PRODUCT SETUP
INSTALLATION
To safeguard against the installation of a relay without any entered settings, the unit will not allow signaling of any output
relay until
RELAY SETTINGS
UNIT NOT PROGRAMMED
The
setting allows the user to uniquely identify a relay. This name will appear on generated reports. This name
RELAY NAME
is also used to identify specific devices which are engaged in automatically sending/receiving data over the Ethernet com-
munications channel using the IEC 61850 protocol.
5
5-42
has to be programmed on the receiving end.
INSTALLATION
RELAY SETTINGS:
Not Programmed
RELAY NAME:
MESSAGE
Relay-1
is set to "Programmed". This setting is defaulted to "Not Programmed" when at the factory. The
self-test error message is displayed until the relay is put into the "Programmed" state.
D60 Line Distance Relay
is transmitted over both channels; as such,
LOCAL RELAY ID NUMBER
Range: Not Programmed, Programmed
Range: up to 20 alphanumeric characters
5 SETTINGS
5.2.18 INSTALLATION
GE Multilin
Advertisement
Table of Contents
