GE D60 Instruction Manual page 89

4 HUMAN INTERFACES
e) ENTERING INITIAL PASSWORDS
To enter the initial Setting (or Command) Password, proceed as follows:
1. Press the key until the
appears on the display.
2. Press the MESSAGE
3. Press the MESSAGE
SETTINGS
SETTINGS
PRODUCT SETUP
4. After the
CHANGE...PASSWORD
change the selection to "Yes".
5. Press the key and the display will prompt you to
6. Type in a numerical password (up to 10 characters) and press the
7. When the
VERIFY NEW PASSWORD
CHANGE SETTING
PASSWORD: No
CHANGE SETTING
PASSWORD: Yes
8. When the
NEW PASSWORD HAS BEEN STORED
active.
f) CHANGING EXISTING PASSWORD
To change an existing password, follow the instructions in the previous section with the following exception. A message will
prompt you to type in the existing password (for each security level) before a new password can be entered.
In the event that a password has been lost (forgotten), submit the corresponding Encrypted Password from the
menu to the Factory for decoding.
SECURITY
GE Multilin
header flashes momentarily and the
SETTINGS
key until the message appears on the display.
ACCESS LEVEL
key until the
CHANGE SETTING
PASSWORD
SECURITY
message appears on the display, press the VALUE
is displayed, re-type in the same password and press
ENTER NEW
PASSWORD: ##########
message appears, your new Setting (or Command) Password will be
D60 Line Distance Relay
4.2 FACEPLATE INTERFACE
SETTINGS PRODUCT SETUP
(or ) message appears on the display.
COMMAND PASSWORD
ACCESS LEVEL:
Restricted
CHANGE COMMAND
PASSWORD: No
CHANGE SETTING
PASSWORD: No
ENCRYPTED COMMAND
PASSWORD: ----------
ENCRYPTED SETTING
PASSWORD: ----------
.
ENTER NEW PASSWORD
key.
VERIFY NEW
PASSWORD: ##########
NEW PASSWORD
HAS BEEN STORED
message
key or the VALUE key to
.
PASSWORD
4-13
4