Alarm System - BMW S 1000RR Rider's Manual

Alarm system

4
with anti-theft alarm system
OE
(DWA)
48
Activation
Switch on ignition (
DWA Adjusting (
Switch off ignition.
If the DWA is activated, the
DWA is automatically activated
after the ignition is switched
z
off.
Activation takes approximately
30 seconds to complete.
Turn indicators are illuminated
twice.
Confirmation tone sounds
twice (if programmed).
DWA is armed.
Alarm
The alarm can be set off by:
motion sensor
an attempt to use an unau-
thorized key to switch on the
ignition
disconnecting the alarm system
from the motorcycle battery
40).
(alarm system battery takes
49).
over the power supply - alarm
tone only, no illumination of the
turn indicators).
All functions are sustained even
if the internal battery of the anti-
theft alarm system is completely
drained; the only difference is
that an alarm cannot be triggered
if the system is disconnected
from the motorcycle's battery.
An alarm lasts for approximately
26 seconds. During the alarm,
an alarm tone sounds and the
turn indicators flash. The alarm
tone type can be adjusted by
an authorized BMW Motorrad
retailer.
If an alarm was triggered while
the motorcycle was unattended,
the rider is notified accordingly
by an alarm tone sounding once
when the ignition is switched on.
The alarm system LED then in-
dicates the reason for the alarm
signal for one minute.
The meanings of the flash codes
are as follows:
1 flash: Motion sensor 1
2 flashes: Motion sensor 2
3 flashes: Ignition switched on
with unauthorized key
4 flashes: Alarm system is dis-
connected from the motorcycle
battery
5 flashes: Motion sensor 3
Deactivation
Emergency on/off switch (kill
switch) in normal operating po-
sition.
Switch on ignition.
Turn indicators light up once.