BMW S 1000RR Rider's Manual page 79

SETUP DDC-SYS
The
menu has been selected.
FRONT DMP Adjusting
The adjust damping, briefly
press TRIP 1 or SET 2 repeat-
FRONT
edly until in line 3
displayed and in line 4
(Damping).
NOTICE
The display differs when a spring
travel sensor for the front forks is
used (racing accessory).
Press and hold SET 2.
sub- The value next to
flashes.
Adjust damping as desired with
TRIP 1 and SET 2.
+1 ... +7
in a maximum of seven steps
(harder).
-1 ... -7
in a maximum of seven steps
(softer).
0
: Factory setting
Press and hold SET 2 until dis-
played value no longer flashes.
The value for the current riding
mode is saved.
is
Performing zero position
DMP:
alignment
with Dynamic Damping Control
(DDC) OE
Adjustment is carried out in the
SETUP DDC-SYS submenu.
Place motorcycle on side stand
or a suitable auxiliary stand.
DMP:
: Damping increase
: Damping decrease
During the alignment, do not sit
on the motorcycle and remove
any cargo or luggage.
Select submenu ( 113).
SETUP DDC-SYS
The
menu has been selected.
To set the zero position, briefly
press TRIP 1 or SET 2 repeat-
CALIB
edly until (Calibration)
is displayed in line 4.
Press and hold SET 2 until
CALIB
begins to flash.
CALIB
flashes.
Zero position is calibrated.
5
77
sub-
z