Setting shifting flash
Turn on the
function.
Go to menu
hicle settings
figuration
).
light
The following settings are
available:
Start RPM
End RPM
Brightness
Frequency
quency of 0 Hz corresponds
to continuous lighting.
Changes to the brightness
and the flashing frequency are
signaled by the shiftpoint light
briefly lighting up or flashing.
ANTI-THEFT ALARM SYSTEM
(DWA)
with anti-theft alarm system
(DWA)
OE
Activation
Turn on the ignition. (
Adjust the anti-theft alarm
system. (
Turn off the ignition. (
If DWA is activated, DWA is
automatically activated after
the ignition is switched off.
Activation takes approximately
30 seconds to complete.
Turn signals flash twice.
Shift light
,
Settings
Ve-
,
Con-
(under
Shift
. A flashing fre-
60)
76)
60)
Confirmation tone sounds
twice (if programmed).
Anti-theft alarm system is ac-
tive.
Alarm signal
The DWA alarm signal can be
triggered by:
Tilt alarm sensor
Switch-on attempt with an
unauthorized ignition key.
Disconnection of the DWA
from the vehicle battery (DWA
battery takes over the power
supply – alarm tone only, turn
signals do not flash)
If the DWA battery is dis-
charged, all functions remain
operational; the only difference
is that the alarm cannot be
triggered if the system is
disconnected from the vehicle
battery.
The duration of the alarm sig-
nal is approx. 26 seconds. Dur-
ing the alarm, an alarm tone
sounds and the turn signals
blink. The type of alarm tone
can be set by an authorized
BMW Motorrad dealer.
75