Printer Initialization - AMT Datasouth Fastmark M5e User Manual

Printer initialization

Printer initialization is used to clear DRAM and restore printer settings to defaults.
The only one exception is ribbon sensitivity, which will note be restored to
default.
1.
Turn OFF the power switch
2.
Hold on the button then turn ON the power switch
3.
Release the button when the LED becomes
green will do during the 5 blinks)
 The LED color will change in the following order:

Green

(5 blinks)
Printer initialization will restore setting accordingly:
Speed
Density
Label Width
Label Height
Sensor Type
Gap Setting
Print Direction
Reference Point
Offset
Tear Mode
Peel off Mode
Cutter Mode
Serial Port Settings
Code Page
Country Code
Clear Flash Memory
IP Address

amber red (5 blinks)

red/amber (5 blinks)
Parameter
green

amber (5 blinks)
solid green
Release button
Default setting
3ips (76 mm/sec) (300DPI)
8
4" (101.5 mm)
4" (101.5 mm)
Gap sensor
0.12" (3.0 mm)
0
0,0 (upper left corner)
0
On
Off
Off
9600 bps, none parity, 8 data bits, 1 stop bit
850
001
No
DHCP
- 32 -
and blinking. (Any

green (5 blinks)

green/amber