AMT Datasouth Fastmark M5e User Manual page 40

Item Description
Use this item to setup print darkness. The available
Darkness
setting is from 0 to 30, incremented by 1. You may need
to adjust your density based on selected media.
Use this item to setup print speed. Each increase or
Print Speed
decrease is 1 ips. Available setting is from 1 to 6.
This item is used to fine tune media stop location.
Available setting value is from "+" to "-" or "0" to "120"
Tear Off
dots.
This item is used to set the print mode. There are 3
modes as listed below:
Print mode
This item is used to set print width. The available value is
Print Width
from "0" to "832" dots.
This feature is used to print current printer available font
lists. The fonts stored in the printer's DRAM, Flash or
List Fonts
optional memory card.
This feature is used to print current printer available
image lists. The images stored in the printer's DRAM,
List Images
Flash or optional memory card.
This feature is used to print current printer available
format lists. The formats stored in the printer's DRAM,
List Formats
Flash or optional memory card.
This feature is used to print current printer configuration
List Setup
on the label.
Control Prefix
This feature is used to set control prefix character.
Format Prefix
This feature is used to set format prefix character.
Delimiter
This feature is used to set delimiter character.
Char
Printer
Description
Mode
Next label top of form is aligned to the print
Tear Off
head burn line location.
Peeler Off Enable the label peel off mode.
Cutter Enable the label cutter mode
- 40 -
Default
16
N/A
+000
Tear Off
812 dots
N/A
N/A
N/A
N/A
N/A
N/A
N/A