Toro 34215 Operator's Manual page 65

Note: Run the sprayer nozzle until the narrow
nozzle is spraying air.
E. Push forward the narrow-spray pattern lever and
pull back the wide-spray pattern lever.
Note: Run the sprayer nozzles until the both
wide nozzles are spraying air.
F. Push forward the wide-spray pattern lever.
3. Shut off the sprayer pump and the engine.
Preparing the Sprayer System
Antifreeze type: 2.5 L (0.7 US gallon) rust inhibiting,
non-alcohol based, RV-antifreeze concentrate
Important: Do not allow all of the antifreeze mixture to
empty from the sprayer tank while running the sprayer
nozzles and wand. Keeping some of the antifreeze in
the pump, valves, and hoses will help prevent corrosion
and damage caused by moist air trapped in the sprayer
system.
1. Mix 2.5 L (0.7 US gallon) RV anti-freeze concentrate
with 5.1 L (1.3 US gallon) water and pour the antifreeze
mixture into the into the sprayer tank.
Note: Use a rust inhibiting, non-alcohol based, RV
antifreeze concentrate.
2. Start the machine and set the sprayer-pump switch to
the O position.
N
3. Pull back the narrow-spray pattern lever to the O
position.
Note: Allow the antifreeze to circulate through
sprayer and nozzle.
4. Push forward the narrow-spray pattern lever and pull
back the wide-spray pattern lever.
Note: Allow the antifreeze to circulate through
sprayer and nozzle.
5. Push forward the wide-spray pattern lever.
6. Remove the wand from its holder, point it in a safe
direction, and squeeze the spray-wand trigger.
Note: Allow the antifreeze to circulate through sprayer
and nozzle and then return the wand to its holder.
7. Set the sprayer-pump switch to the O
shut off the engine.
N
position and
FF
65