Operating The Sprayer - Toro 34215 Operator's Manual

Note: Do not use a power washer to clean
the machine. The high-pressure water can force
residual-corrosive materials into spreader-spreader
components.
5. Tilt the screen at the bottom of the hopper forward to
clean the bottom components of hopper
Figure 37
6. When the hopper and screen have been thoroughly
rinsed and drained, perform the following:
A. Rotate the hopper screen down.
B. Place the rate gate dial to a setting lower than
the maximum open position and allow the
spreader-sprayer to completely
C. Connect the hopper gate cable; refer to step
Emptying the Hopper (page
7. Apply water-displacing lubricant to the components as
shown in Figure 38.
Figure 38

Operating the Sprayer

Chemicals are hazardous and can cause personal
injury.
(Figure 37).
Use the sprayer to disperse liquid herbicides, pesticides,
fertilizers, and other substances. Before using the sprayer
ensure that you have cleaned the tank, plumbing, and nozzles
before adding any chemicals. When you use the sprayer, you
first fill the spray tank, then apply the chemical solution to the
work site, and then when you are finished spraying, clean the
tank. It is important to complete all three of these steps to
avoid damaging the sprayer. For example, Do not mix and add
chemicals in the spray tank the night before and then spray in
the morning. This could lead to separation of the chemicals
and possible cause damage to components of the sprayer.
dry.(Figure 29).
8 in
28).
34
CAUTION
• Read the chemical manufacture's directions
on the label before handling the chemicals;
follow all manufacturer recommendations and
precautions.
• Keep chemicals away from your skin. Should
contact occur, wash the affected area thoroughly
with soap and clean water.
• Wear eye protection, gloves, and any other
protective equipment recommended by the
chemical manufacturer.