Controls System Maintenance; Adjusting The Pattern Control Cable For The Spreader - Toro 34215 Operator's Manual

Controls System
Maintenance
Adjusting the Pattern Control
Cable for the Spreader
1. Shut off the engine, set the parking brake, remove the
key, and wait for all moving parts to stop before leaving
the operating position.
2. Empty the hopper; refer to
(page 28)
3. Close the impeller gate by pushing the wide-distribution
impeller-gate lever forward fully
Figure 82
1. Unlock—spread pattern
control handle (rotate
counterclockwise)
2. Push down—spread
pattern control handle
4. Rotate the spread-pattern-control handle
counterclockwise, push the handle down, and rotate
the spread-pattern-control handle clockwise(3) refer
to Figure 82.
5. Loosen the jam nut at the end of the pattern-control
cable (Figure 83).
Emptying the Hopper
(Figure 82).
3. Lock—spread pattern
control handle (rotate
clockwise)
4. Push
forward—wide-distribution
impeller-gate lever
1. Jam nut (pattern control cable)
2. Linkage rod
3. Impeller shaft
4. 1/8 inch (3.2 mm) gap between ramp tooth and impeller
shaft
5. Ramp tooth
6. Pull the linkage rod until there is 1/8 inch (3.2 mm)
gap between the ramp tooth and the impeller shaft
(Figure 83).
7. Tighten the jam nut
8. Adjust the spread-pattern-control handle; refer to
Adjusting the Spreader Pattern (page
62
Figure 83
(Figure 83).
31).