Operating The Machine - Toro 34215 Operator's Manual

Operating the Machine

CAUTION
Chemicals are hazardous and can cause personal
injury.
• Read the chemical manufacture's directions
on the label before handling the chemicals;
follow all manufacturer recommendations and
precautions.
• Keep chemicals away from your skin. Should
contact occur, wash the affected area thoroughly
with soap and clean water.
• Wear eye protection, gloves, and any other
protective equipment recommended by the
chemical manufacturer.
Extending and Retracting the
Operator's Platform
Extending the Operator's Platform
Extend the platform as follows:
1. Pull inward the knob for the platform lock until the pin
of the lock clears the upper hole in the chassis
19).
1. Platform-lock knob
2. Operator's platform
Figure 19
3. Lower chassis hole
2. Rotate the operator's platform down until the pin of
the platform lock is aligned with the lower hole in the
chassis
3. Move the knob for the platform lock outward until the
pin for the lock is protruding through the lower hole
(Figure
Retracting the Operator's Platform
1. Pull inward the knob for the platform lock until the pin
of the lock clears the upper hole in the chassis
19).
2. Rotate the operator's platform up until the pin of the
platform lock is aligned with the upper hole in the
chassis
3. Move the knob for the platform lock outward until the
pin for the lock is protruding through the upper hole
(Figure
Opening and Closing the Fuel-Shut-Off
Valve
Control fuel flow to the engine with the fuel-shut-off valve
as follows:
•
Rotate the handle for the fuel-shut-off valve 90 degrees
clockwise to the open the valve.
•
Rotate fuel-shut-off valve handle 90 degrees
(Figure
counterclockwise to close the valve.
1. Fuel tank
2. Fuel-shutoff valve (open
position)
23
(Figure 19).
19).
(Figure 19).
19).
Figure 20
3. Fuel-shutoff valve (closed
position)
(Figure