Toro 34215 Operator's Manual page 41

the chemicals to dry or thicken in the lines, clogging the
pump and other components.
1. Empty the sprayer tank; refer to
Tank (page 40).
2. Fill the sprayer tank with 19 L (5 US gallons) or more
of clean water and install the cap; refer to
Spray Tank (page 39).
3. Start the engine (Figure
motion-control lever in N
Starting the Engine (page
1. Ignition switch
2. Agitation-pump lever
3. Narrow-spray pattern lever 7. Sprayer-pump/tank-agitation
4. Wide-spray pattern lever
4. Set the sprayer-pump switch to the O
set the engine throttle to F
5. Move the tank-agitation lever to the O
(Figure 46).
6. Pull back both narrow and wide-spray pattern levers to
the O position (Figure
N
Note: The sprayer nozzles will to begin spraying.
7. Allow the rinse water in the tank to spray through the
nozzles.
8. Check that all 3 nozzles are spraying correctly.
9. Remove the sprayer wand from the holder, point the
wand in a safe direction, and squeeze the trigger; refer
to Spray-Wand Trigger and Trigger Lock (page
Note: Allow the rinse water to discharge from the
wand for 1 to 2 minutes.
10. Release the trigger for the wand and return it to the
holder on the machine
Emptying the Sprayer
Filling the
46) and ensure that the
position; refer to
EUTRAL
24).
Figure 46
5. Choke
6. Throttle
switch
position, and
N
position (Figure
AST
position
N
46).
(Figure 8).
11. Move the spray-pattern levers forward to the O
position, set the sprayer-pump switch to the O
position, and shut off the engine
12. Clean the strainer; refer to
41)
13. Repeat steps
neutralizers recommended by the chemical
manufacturers; refer to
14. Repeat steps
15. Using a hose to wash off the outside of the sprayer
tank with clean water.
Note: Do not use a power washer to clean the
machine. The high-pressure water may force residual
corrosive materials into spreader-spreader components.
16. Remove and clean the sprayer nozzles; refer to
the Sprayer Nozzle (page
Note: Replace damaged or worn nozzles.
17. Allow the spreader-sprayer to completely dry before
the next use.
Cleaning the Strainer
Service Interval: After each use
Important: If you used wettable-powder chemicals,
clean the strainer after each time that you rinse the
sprayer tank.
1. Empty the tank; refer to
(page 40)
2. Rotate the handle for the supply valve 90°
counterclockwise
46).
1. Pump-shutoff valve
18).
3. Align a drain pan under the strainer
4. Rotate the strainer bowl counterclockwise and remove
the bowl and screen from the body of the strainer
(Figure
Note: Remove the strainer bowl by hand.
41
Cleaning the Strainer (page
2 through 12 using cleaners and
Filling the Spray Tank (page
2 through 12 using clean water only.
42).
Emptying the Sprayer Tank
(Figure 47).
Figure 47
2. Strainer
48).
FF
FF
(Figure 46).
39).
Cleaning
(Figure 47).