Safety Measures During Operation; Safety Devices - Optimum B 24 H Operating Manual

OPTIMUM
M A S C H I N E N - G E R M A N Y

document training / instructions,

require the staff to confirm participation in training / instructions by means of a signature,

check if the staff is aware of safety rules and dangers in the workplace so that they observe
the operating manual.
The user must

Obligations have followed a training on the operation of the bench drill and upright drill,
of the user

know the function and performance,

before commissioning
- have read and understood the operating manual,
- be familiar with all safety devices and regulations.
Further For working on the following machine parts, additional requirements are being applied:
require-

Electrical parts or operating agents: shall only be performed by an electrician or under the
ments to the
guidance and supervision of an electrician.
qualification
Before starting work on electrical parts or operating agents, following measures are to be per-
formed in the following order:
Disconnect main electrical power.
Ensure that the machine cannot be turned on again.
Check that there is no voltage.
1.5

Safety measures during operation

CAUTION!
Risk due to inhaling of health hazardous dusts and mist.
Dependent on the material which need to be processed and the used auxiliaries dusts
and mist may be caused which might impair you health.
Make sure that the generated health hazardous dusts and mist are safely sucked off at
the point of origin and is dissipated or filtered from the working area. Use an appropriate
suction unit.
CAUTION!
Risk of fire and explosion by using flammable materials or cooling lubricants.
Take additional preventive measures in order to safely avoid health hazards before
processing flammable materials (e.g. aluminum, magnesium) or before using flammable
additives (e.g. solvents).
1.6

Safety devices

Operate the bench drill and upright drill only with properly functioning safety devices.
Stop the bench drill and upright drill immediately if there is a failure in the safety device or if it is
not functioning for some reason.
It is your responsibility!
If the safety device has been activated or has failed, the bench drill and upright drill must only be
operated again when

the cause of the failure has been removed,

you have made sure that there is no existing danger for persons or objects.
Page 10 Safety Bench drill and upright drill B24H ; B28H (B) (Vario) ; Version 2.1.7
Safety
21 / 07 / 2014