Technical Data
2.5
2.6
2.7
2.8
2.9
Emissions
The noise level emission of the bench drill and upright drill is below 76 dB(A). If the bench drill
and upright drill is installed in an area where various machines are in operation, the acoustic
influence (immission) on the operator of the bench drill and upright drill may exceed 85 dB(A).
INFORMATION
This numeric value had been measured on a new machine under conventional operating condi-
tions. Depending on the age or wear of the machine, the noise behavior of the machine might
change.
Furthermore, the extent of the noise emission is also depending on manufacturing
influence factors, such as speed, material and clamping conditions.
INFORMATION
The mentioned numerical value is an emission level and not necessarily a safe
working level.
21 / 07 / 2014
Required space
Height
Depth
Width
Speeds
Spindle speeds [rpm]
Number of stages
Spindle speeds [rpm]
Number of stages
Environmental
conditions
Temperature
Rel. humidity
Operating material
Toothed rack
Column
Technical Data Bench drill and upright drill B24H ; B28H (B) (Vario) ; Version 2.1.7
OPTIMUM
M A S C H I N E N - G E R M A N Y
B 24 H
1850mm (72.84")
1700mm (66.93")
1500mm (59.06")
B 24 H
420 - 4000
7
B 28 H Vario
35 - 4000
12
B 24 H
41 - 95 °F
25 - 80 %
B 24 H
commercial lubricating grease
acid-free lubricating oil, e.g. machine oil, motor
oil
B 28 HB, B 28 H
(Vario)
2000 (78.74")
B 28 HB
1850mm (72.84")
1800mm (70.87")
1600mm (62.99")
B 28 HB, B 28 H
262 - 4075
16
B 28 HB, B 28 H
(Vario)
B 28 HB, B 28 H
(Vario)
Page 17