Upper Deck Lift Service; Upper Deck Lift Removal; Upper Deck Lift Installaton - Toro TimeCutter SW4200 Service Manual

Upper Deck Lift Service

Upper Deck Lift Removal

1. Raise seat and disconnect battery terminals.
2. Remove the RH fender / pod as shown in this
chapter.
3. Move the deck HOC to the middle position.
4. Support deck in current position, then move deck
HOC to the lowest position.
5. Remove the pins and washers (A) that attach the
foot lift rod (B) and remove the rod from the unit (if
equipped).
6. Remove the (2) fasteners that secure the foot
pedal bracket (C) to the frame. Remove foot pedal
assembly from frame (if equipped).
7. Remove the (2) pins and (2) washers that attach the
lift links (D) to the deck lift (E).
8. Remove the (4) fasteners attaching the (2) lift
brackets (F) to the main frame.
9. Remove deck lift assembly (E) from frame.
Toro TimeCutter SW/SWX Service Manual
Upper Deck Lift Installation
1. Maneuver the deck lift assembly (E) into position
from the RH side of the unit.
2. Install the (2) lift brackets (F) and torque fastener to
specification - 14 ft-lbs. (19 Nm).
3. Slide the lift links (D) onto the deck lift posts. Install
the (2) washers and (2) pins that secure the lift links
to the deck lift (E).
4. Install the foot pedal assembly (C) onto the frame
and torque fasteners to specification - 30 ft-lbs.
(40 Nm) (if equipped).
5. Install foot lift rod (B) into foot pedal and foot lift plate
(G). Install the washers and pins that retain it (if
equipped).
6. Lift deck upward and remove supports.
7. Install the RH fender assembly as outlined in this
chapter.
8. Connect the battery terminals.
9. Cycle the deck through the HOC range and verify
proper function. Inspect the PTO deck belt for proper
routing and tension.
10. Level the deck as shown in this service manual, see
"Leveling the Mower Deck", pages 6-22 - 6-35.
(Fig. 027)
CHASSIS
3
3-15