Toro TimeCutter SW4200 Service Manual page 105

MOWER DECK
8� Loosen the rear locking nut (B) on the hanger
bracket just enough to allow the hanger to be
adjusted (Fig� 122)�
C
D
A� Hanger bracket
B� Rear locking nut
6
6-24
A
B
Fig. 122 fig. 50 G015324
C� Side locking nut
slotted position
D� Adjustment notches
9� Use the notches on the welded bracket to measure
the amount of adjustment� Each notch surface is
equivalent to 0�25", while a single side is 0�125" (Fig�
123)� Adjust the height of the mower deck to the
desired height�
A
B
Fig. 123
A� 0�25 inch
10� When at the desired position, tighten the rear locking
nut on the hanger bracket (Fig� 122)� Tighten the
side locking nut on the hanger bracket�
11� Continue leveling the deck by checking the front-to-
rear blade slope; refer to "Adjusting the Front-to-
Rear Blade Slope" in this chapter�
Toro TimeCutter SS/MX/ZS Service Manual
fig. 51 G015325
B� 0�125 inch